#HOW TO CONNECT INTERNET USING LAN CABLE TV#

For cable TV in modern gigabit cable networks or DVB-T reception, the TV signal can be looped through the EoC modem. The television or satellite receiver can be operated as before.

One of these is connected via an Ethernet cable to the Internet router and via a coaxial cable вЂ“ an antenna cable вЂ“ to the return channel-capable antenna socket or the SAT multi-switch.ДЇor cable TV, an intermediate plug is still necessary: For EOC 1-31 or 2-31 from Axing a high-pass filter TZU 19-65, for EOC 1-32 and 2-32 a high-pass filter TZU 19-68X.ДЄnother EOC 1-32 modem is connected to the antenna socket of a remote room and one or two computers are connected to its Ethernet port. EOC 1-32 from Axing) are all that is needed to get started. If there is any uncertainty, the TV distribution system should be checked вЂ“ it may be necessary to replace components in the system first. In any case, the TV cable in the house must be backward channel-compatible. Otherwise, when using these two modules, the TV programmes transmitted below this frequency are omitted. It is important to note that modems such as EOC 1-32 and EOC 2-32 should only be used in a CATV network (cable TV) if the forward path frequency range starts at 258 MHz. The individual devices differ in terms of transfer rate, frequency range and whether the setup is only via Ethernet or also WLAN. Ethernet-over-Coax is therefore many times more secure than Powerline. Antenna cables, on the other hand, are only in the house itself, there is no connection to the environment and they thus offer no additional point of attack for possible intruders. In addition, the power grid of a house is connected to the outside world and is therefore open and unsecured. As a result, the data rate drops very quickly over longer distances. However, in contrast to antenna cables, there is a decisive difference: power cables are not shielded and have high losses when transmitting data.

These are also a convenient solution to the problem of house-wide networking. Safer than a power lineДЇor a long time now, there have been solutions that route internet data via existing power cables (powerline). Thanks to Ethernet-over-Coax, it is possible to use these for internet signals in addition to television. The solution to this problem is called Ethernet-over-Coax: in many buildings there are already cables for connecting television and radio in the walls, and there is a connection socket in every room. And providing all the rooms with Ethernet connections means an immense construction effort.

But how do you supply a large building with many rooms? A WLAN network would not reach everywhere, and WLAN repeaters are also only a solution to a limited extent. Fast, always-on connections for the home are already available for a small monthly fee, and a WLAN router distributes the data wirelessly throughout the house. Today, being able to use the internet seems almost a matter of course. Required: Router, internet access and PC, laptop or tablet The solution to connection problems EOC 1-32 from Axing)Д¬an be extended with: further modules (e.g. This is often already in place but Ethernet over Coax makes it possible to use existing antenna cables as data lines. If you want to have internet access in a building with multiple rooms like hotels, retirement homes, schools or a large house, you need a lot of wiring. Ethernet over Coax: A stable internet connection in every room

How to connect internet using lan cable